• 40MHz Channel Location: Configure the 40MHz channel location
when using 20MHz/40MHz in Channel Width, users can set it to be
Secondary below Primary, Primary below Secondary or Auto.
• Channel: Select Auto, or a specified channel, default is Auto. Note
that the proposed channels depend on Country Settings under
System Settings→Maintenance.
• Radio Power: Set the Radio Power, it can be Low, Medium or High,
or Dynamically assigned by RRM (AP will actively change TX power
depending on RRM settings).
• Enable Short Guard Interval: Check to activate this option to
increase throughput.
• Custom Wireless Power(dBm): allows users to set a custom
wireless power for both 5GHz/2.4GHz band, the value of this field
must be between 1 and 31.
• Allow Legacy Devices(802.11b): Check to support 802.11b devices
to connect the AP in 802.11n/g mode. (2.4GHz setting)
• Dynamic Channel Assignment: Once enabled, AP will try to allocate
and move the best channel during operation, unlike Auto Channel
Selection (ACS) which scan and assign channel when Wi-Fi interface
goes up for one time.
This feature is not supported on GWN7602.
• Transmit Power Control: TPC algorithm runs every 10 minutes. AP
acquires the RSSI information of the neighbor by wireless scanning
and establishes the neighbor table. The algorithm requires that there
must be at least 3 neighbor APs with RSSI larger than -70dbm.
Otherwise, power will not be adjusted.
This feature is not supported on GWN7602.
Coverage Hole Detection: CHD enables AP to decide whether to
increase the AP power by the current SNR and SNR threshold of the
connected clients.
This feature is not supported on GWN7602.
• Enable Minimum RSSI: Check to enable RSSI function, this will lead
the AP to disconnect users below the configured threshold in
Minimum RSSI (dBm).
• Minimum RSSI: Enter the minimum RSSI value in dBm. If the signal
value is lower than the configured minimum value, the client will be
disconnected. The input range is from “-94” or “-1”.